Services Provided by Servo Motors Australia.
- Evaluation and Quote
- Service, Remanufacture, Repair & Rewinding of all AC, DC & Permanent Magnet Servo Motors, AC Spindle Motors, Disk/Pancake Motors, Tachometers and Linear Motors.
- Re-magnetising and De-magnetising of Disk/Pancake, Permanent Magnet Electric Motors & Tacho generators.
- Stegmann and Heidenhain Encoder verification testing.
- Testing and reporting on the condition of feedback devices, including digital programmed units
- "BEMF" testing and reporting of Servo, Pancake and AC & DC Permanent Magnet Electric Motors
- Load testing and reporting of Pancake and Permanent Magnet Electric Motors
- Encoder and Resolver alignment using the latest "state of the art" testing equipment.
- Surge Testing using non destructive low Voltage Testing methods
Typical tests and checks carried out on servo motors in our workshop:-
- On entrance to the workshop, take digital photo.
- Carry out testing for - resistance, insulation and inductance.
- Surge test unit to prove
- Check feed back devices to manufacturers specifications.
- Run motor (if possible) check against manufacturers specs.
- Check bearing housings and shafts to mechanical tolerances.
- Check magnets to manufacturers specs (if required)
- Quote to customer for approval to repair
- After customer approval
- Clean all parts of the motor
- Rewind Stator (if required)
- Carry out repairs to housings, shafts (if required)
- Replace all bearings and seals
- Reassemble motor
- Install feed back unit, to manufactures specifications.
- Test both statically and dynamically to ensure correct operation.
- Set up and calibrate resolvers, tachometers and encoders to correct signal and position.
- Set brake to manufacturers holding torque settings. (if applicable)
- Run test to prove motor and feed back unit
- Check motor to manufacturers specs and digital entrance photo
- Paint
- Final inspection and return to customer.